Logo

P1692 Engine Code Repair

Meaning of P1692 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P1692 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P1692 code is occuring now you should check P1692 repair processes.
Now don't ask yourself; What should you do with P1692 code ?
The solution is here :

P1692 Possible Solution:

P1692 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

P1692 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

1
Fuel And Air Metering

6
Fuel Composition Sensor Circuit Malfunction

9
Ignition/Distributor Engine Speed Input Circuit Malfunction

2
Crankshaft Position Sensor A Circuit Low Input

Regarding the P1692 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P1692 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P1692 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For P1692 Code

The reason of P1692 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

P1692 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.